Settings; Setting The Tear Position - TallyGenicom 2150 Quick Start Manual

Quick Start-up

Settings

This section describes how to set the tear position, the first printing line, the print head gap as
well as the font and the character density.
Setting the tear If the tear position of the paper is not aligned with the tear edge of the printer, you can adjust it.
position
Loaded paper may have to be torn and repositioned to the park position.
Adjust Paperway
Menu Char Online
3
1 2 4
Setup
TOF
Head Tear Online
1 2 3 4
Setup
TearAdj= 00/72"*
Set < > Exit Online
1 2 3 4
Setup
Press the Setup key. The printer changes to setup mode.
Press the Adjust (2) key.
Press the Tear (4) key.
>
Press the < (2) or (3) key to move the perforation to the desired position.
Confirm the setting by pressing the Set (1) key.
Press the Setup key. The printer is reset to the initial status.
The correction made will be retained after switching off the printer.
Settings
S H
L I
G
E N
19