Selecting Character Density And Font - TallyGenicom 2150 Quick Start Manual

Settings
Selecting character
You can use the CPI key in setup mode to select the number of characters per inch to be printed.
density and font You can use the Font key to select fonts.
Adjust Paperway
Menu Char Online
1 2 3 4
Setup
Font CPI
Online
1 2 3 4
Setup
10 CPI *
Set < > Exit Online
1 2 3 4
Setup
ROMAN NLQ
Online
Set < > Exit
1 2 3 4
Setup
Adjust Paperway
Menu Char Online
1 2 3 4
Setup
22
Press the Setup key, then the Char (4) key.
Press the CPI (3) or Font (2) key (in our example, press CPI).
>
Use the < (2) or (3) key to set the desired character density. Confirm the
selection by pressing the Set (1) key.
You can cancel the selection and leave the setting unchanged by pressing the
Exit (4) key.
If you pressed the Font key, use the < (2) or
Confirm the selection by pressing the Set (1) key.
You can cancel the selection and leave the setting unchanged by pressing the
Exit (4) key.
Press the Setup key. The printer is reset to the initial status. It is also possible
to press the Online key. The printer then changes directly to online mode.
The selection made is not retained after switching off the printer.
For details on the permanent setting of the character density, refer
to the reference manual on the online CD-ROM.
Quick Start-up
>
(3) key to select the desired font.