Table of Contents
Advertisement
Quick Start-up
Checking the printer
Make sure that the device has been set to the correct voltage (e.g. 230 V in Europe, 120 V in the
voltage
USA). To do this, check the type plate above the power inlet at the back of the printer.
Never switch on the printer if the voltage setting is incorrect, since this may result in severe
STOP
damage.
Front side of printer
Back side of printer
You can set the printer to the correct mains voltage yourself. To
do this, cautiously place the printer on its back side.
Use a suitable object (e.g. a screwdriver, but never a pencil) to
set the slide switch on the left at the bottom of the printer to the
correct voltage.
Installation
S H
L I
G
E N
7
Advertisement
Table of Contents
