Table of Contents
Advertisement
7. Check where the control lever is relative to
notch in console (Figure 68). It should be
centered allowing lever to pivot outward to the
neutral lock position.
Figure 68
1. Neutral locked position
2. Control lever
8. If adjustment is needed, loosen the nut and
jam nut against the yoke (Figure 69).
9. Apply slight rearward pressure on the motion
control lever, turn the head of the adjustment
bolt in the appropriate direction until the
control lever is centered in the neutral lock
position (Figure 69).
Note: Keeping rearward pressure on the
lever will keep the pin at the end of the slot and
allow the adjustment bolt to move the lever to
the appropriate position.
10. Tighten the nut and jam nut (Figure 69).
11. Repeat for the opposite side of the machine.
3. Neutral potion
Figure 69
1. Clevis pin in slot
2. Nut against yoke
3. Adjustment bolt
4. Pump rod
5. Double nuts
6. Jam Nut
Hydraulic System
Maintenance
Servicing the Hydraulic
System
Checking the Hydraulic Fluid
Fluid Type: Mobil 1 15W-50 synthetic motor oil or
equivalent synthetic oil.
Important: Use oil specified or equivalent.
Other fluids could cause system damage.
Hydraulic System Oil Capacity: 132 ounces (3.9 l)
Check the hydraulic fluid level:
• Before the engine is first started.
• After the first 8 operating hours.
• After every 25 operating hours.
Note: There are two ways of checking the
hydraulic oil. One is when the oil is warm and one
is when the oil is cold. The baffle inside the tank
has two levels depending if the oil is warm or cold.
1. Position the machine on a level surface and set
the parking brake.
52
7. Spring
8. Pivot shaft
9. Yoke
10. Locknut
11. Ball joint
12. Tracking knob
Advertisement
Table of Contents
