Think Safety First - Toro Z Master Z597-D Operator's Manual

2. Remove the hairpin cotter pins and remove the
two pins (Figure 7).
3. Lower the the roll bar to the down position.
There are two down positions. See Figure 6
for the positions.
4. Install the two pins and secure them with the
hairpin cotter pins (Figure 7).
Figure 6
1. Full down position
Important: Ensure that the rear part of
the seat is secured with the seat latch.
5. To raise the roll bar, remove the hairpin cotter
pins and remove the two pins (Figure 7).
6. Raise the roll bar to the upright position and
install the two pins and secure them with the
hairpin cotter pins (Figure 7).
Important: Always use the seat belt with
the roll bar in the raised position.
2. Down position with bagger
installed
Figure 7
1. Roll bar
2. Raised position
Important: Tighten the front knobs
against the center roll bar ends (Figure 8).
Figure 8
1. Front handle

Think Safety First

Please read all safety instructions and symbols
in the safety section. Knowing this information
could help you or bystanders avoid injury.
20
3. Pin
4. Hairpin cotter pin