Adjusting The Flow Baffle - Toro Z Master Z597-D Operator's Manual

3. After adjusting the height-of-cut, adjust the
rollers by removing the flange nut, bushing,
spacer, and bolt (Figure 20 , Figure 21 and
Figure 22 ).
Note: The two middle rollers will not have a
spacer (Figure 21).
4. Select a hole so the anti-scalp roller is
positioned to the nearest corresponding
height-of-cut desired.
5. Install the flange nut bushing, spacer, and bolt.
Torque to 40-45 ft-lb (54-61 N•m) (Figure 20 ,
Figure 21 and Figure 22 ).
6. Repeat this adjustment on the other anti-scalp
rollers.
Figure 20
1. Anti-scalp roller
2. Spacer
3. Bushing
Figure 21
1. Anti-scalp roller
2. Bushing
4. Flange Nut
5. Bolt
3. Flange Nut
4. Bolt
Figure 22
1. Anti-scalp roller
2. Spacer
3. Bushing
Adjusting the Flow Bafe
The mower discharge flow can be adjusted for
different types of mowing conditions. Position the
cam locks and baffle to give the best quality of cut.
1. Disengage the PTO, move the motion control
levers to the neutral locked position and set
the parking brake.
2. Stop the engine, remove the key, and wait for
all moving parts to stop before leaving the
operating position.
3. To adjust the cam locks, swing the lever up to
loosen the cam lock (Figure 23).
4. Adjust the baffle and cam locks in the slots to
the desired discharge flow.
5. Swing the lever back over to tighten the baffle
and cam locks (Figure 23).
6. If the cams do not lock the baffle into place or
it is too tight, loosen the lever and then rotate
the cam lock. Adjust the cam lock until the
desired locking pressure is achieved.
27
4. Flange Nut
5. Bolt