Connecting The Sensor Head - Omron ZS-HL Series User Manual

Connecting the Sensor Head

This connector connects the Sensor Head and controller.
Before connecting/disconnecting the Sensor Head, make sure that the Smart Sensor is turned OFF. The
Sensor Controller may break down if it is connected or disconnected while the power is ON.
 Connecting the Sensor Head
Insert the Sensor Head connector into the Sensor Controller until it locks in place.
Ferrite core
Attach the ferrite core (provided with the Sensor Head) to both ends of the Sensor Head cable in
advance.
If the ferrite core comes loose from the cable, fasten the ferrite core in place with the Insure Lock
(supplied).
 Disconnecting the Sensor Head
Pull out the Sensor Head while pressing in the hooks on both sides of the Sensor Head
connector.
• Do not touch the terminals inside the connector.
• All settings on the Sensor Controller will be cleared if the Sensor Head is replaced with a different
type.
Insure lock
Ferrite core
Section2
Sensor Head
ZS-HL
2-5
User's Manual