Table of Contents
Advertisement
Names
(5)
FAR Indicator
(6)
NEAR Indicator
Sensor Controller
(12) HIGH indicator
(11) PASS indicator
(10) LOW indicator
(9) Threshold switch
(18) USB port
Names
(1)
Laser indicator
(2)
Zero Reset indicator
These indicators light up as follows according to the distance between the front of the
Sensor Head and the workpiece.
Both NEAR/FAR indicators are lit up: Measuring center distance ± (measuring range
NEAR indicator is lit up: Near side within measuring range
FAR indicator is lit up: Far side within measuring range
Both NEAR and FAR indicators are flashing: Outside measuring range
These indicators also double as laser alarm indicators.
- At least one of the indicators will either light up or flash after the Sensor
Head is turned ON.
- Both indicators go out for 15 to 25 seconds after the Sensor Head is turned
ON to indicate that the laser beam is OFF.
- Either of these indicators will light up or flash while the laser beam is being
emitted.
- Both indicators go off when the laser beam is OFF.
LD ON ZERO ENABLE
H
P
L
(17) I/O cable
The Laser indicator is lit while the Sensor Head is emitting a laser beam.
The Zero Reset indicator is lit while the zero reset function is enabled.
Part Names and Functions
Functions
× 10 %)
(13) Sensor Head connector
(1) Laser indicator
(2) Zero Reset indicator
(3) ENABLE indicator
(4) Main display
(5) Sub-display
(6) LCD screen
(7) Control keys
(8) Mode switch
(15) RS-232C connector
(16) Voltage/Current switch
Functions
Section 1
(14) Coupler
ZS-HL
1-5
User's Manual
Advertisement
Table of Contents
