Microphone - THOMSON RP5430 Operator's Manual

Microphone

3
To attach the optional microphone (AJ MC700) to the
camera proceed as follows:
a. Open the microphone holder by unscrewing the
knurled screw of the microphone support bracket
1
on the viewfinder and open.
2
b. Slide the microphone into the split tube until the
microphone shoulder reaches the mark
tube.
c. Place the tube with the microphone into the holder
with the split facing upwards.
d. Ensure that the rubber supports at the back and
front of the holder fit into the rims
tube.
e. Close the holder and tighten the knurled screw at
the top.
f. Connect the microphone cable to audio connector
(mic) on the right side of the camera.
3
g. Place the microphone cable into the top clip at the
front of the camera and into clip
camera.(Pull and twist clip
Assembling the Units
5
2
1
4
in the
5
around the
6
at the side of the
4
to open it.)
4
Operator's Manual LDK 200 Triax
6
Other microphones with a diameter of 21mm can
also be used, however, ensure that the phantom
power and the sensitivity of the input that match that
type of microphone are correctly selected in the
camera systems menu. Refer to Section 6 for more
information on selecting the audio inputs and
controlling the audio level.
Note:
· When longer microphones are used, it is not
necessary to place them in the split tube.
· For optimum operation, the microphone should be
mounted as straight as possible.
· Don't allow the wind hood to touch the holder
this reduces the damping effect.
· By placing the split facing upwards, the microphone
cable does not touch the holder thus avoiding
mechanical pick-up.
· The microphone can also be connected to the rear
of the Triax adapter where a switch selects the
input. Refer to Section 4 for more information on
connecting the microphone to the rear connector.
6
7
as
7
2-7