Setup; When You Use This Product For The First Time - Epson TM-C3400BK Technical Reference Manual

Setup

This chapter describes setup and installation of the product and peripherals.

When You Use This Product for the First Time

Do not turn on the printer power until installation of the printer driver is completed.
Ink charging and media position detection setting are necessary before you use this product for
the first time.
Follow the steps below.
1
Load the roll paper.
For details, see
2
Turn on the printer.
3
Load a new ink cartridge.
For details, see
 Ink charging starts after the ink cartridge cover is closed.
 When the ink cartridge is installed for the first time, the printer takes
 When ink charging finishes, the POWER LED stops flashing and stays on.
4
Set the media position detection of the printer for the paper type you
will be using.
For details, see
 The colors of printouts may become abnormal if you tilt this product or subject the printer
 If the colors of printouts are not normal, perform head cleaning. See
 If you turn the printer off without using the power switch, the print head may not return to
Loading/Replacing the Roll Paper on page
Loading/Replacing the Ink Cartridge on page
approximately 8 minutes for ink charging.
The POWER LED flashes during ink charging. Do not turn
off the printer or open the roll paper cover or the ink car-
tridge cover.
If the power is turned off, the roll paper cover is opened, or
the ink cartridge cover is opened during ink charging, ink
charging will restart from the beginning and an extremely
large amount of ink will be consumed.
2. Setting for media position detection on page
to any shocks. When you move this product after ink charging, check the colors by per-
forming a test print.
Cleaning on page 194 for how to perform head cleaning.
its home position. In this case, the next time the printer is turned on, the auto head
cleaning is performed, which wastes ink.
Chapter 2 Setup
76.
63.
79.
Manual Head
2
59