AEG LFR7314O4V User Manual page 27

c) Put the tablets in the compartment
Make sure that the Pods® option is activated.
4. Pour fabric softener in the compartment
.
5. Close the detergent dispenser.
11.4 Setting a programme
1. Turn the programme dial to select the
desired washing programme. The related
programme indicator comes on.
The indicator of the Start/Pause
flashes.
The display shows an indicative programme
duration, the maximum declared load for the
set programme (only for a few seconds), the
default temperature, the default spin speed
and the washing phase indicators (when
available).
2. To change the temperature and/or the
spin speed, touch the related buttons.
3. If desired, set one or more options by
touching the related buttons. The related
indicators come on in the display and the
given information changes accordingly.
In case a selection is not possible, no
indicator comes on and an acoustic
signal sounds.
11.5 Starting a programme
Touch the Start/Pause
programme.
The related indicator stops flashing and stays
on.
In the display, the indicator of the operating
.
phase starts flashing.
The programme starts, the door is locked.
The display shows the indicator
The drain pump can operate shortly
before the appliance fills water.
11.6 Starting a programme with the
Finish In option
1. Touch this repeatedly until the display
shows the desired time within the
programme should end. The indicator
comes on.
2. Touch the Start/Pause
The drum starts rotating to perform the
ProSense estimation, if foreseen in the
selected programme.
3. The appliance starts the countdown to the
end of the programme and the
programme will start at the right moment
for ending at the time set through this
button
option.
To change or cancel this option:
1. Switch the appliance off by means of the
On/Off
2. Switch the appliance on again.
3. Set the programme again.
11.7 The ProSense load detection
The programme duration in the display is
referred to a medium/high load.
button to start the
button.
button.
ENGLISH
.
27