AEG LFR7314O4V User Manual page 16

7.3 Introduction
The options/functions are not selectable
with all washing programmes. Check the
compatibility between options/functions
and washing programmes in the
"Programme Chart". An option/function
can exclude another one, in this case the
appliance doesn't allow you to set the
incompatible options/functions together.
Make sure the screen and touch buttons
are always clean and dry.
7.4 Finish In
Set this option as last after programme
and other options selection, otherwise it
can be cancelled if you change some
setting.
This option allows choosing the time within
which a programme should terminate. The
programme end can be postponed by one 1
hour every button touch until 24 hours
maximum.
The display shows the normal programme
duration alternatively with the set programme
end time (expressed in hours 0h). The
minimum selectable time corresponds to
rounded up hour of the maximum duration of
a programme (e.g. if the cycle duration lasts
3:15 hours, the minimum selectable time will
be 4h).
After programme start, the door is locked and
the appliance starts the ProSense phase.
When load estimation ends, on the display
the icon of running phase blinks and the time
digit counts down in steps of one hour and in
steps of 1 minute during the last hour.
7.5 Start/Pause
Touch the Start/Pause
pause the appliance or interrupt a running
programme.
7.6 PODS®
Touch this button to activate or deactivate the
PODS® option .
16 ENGLISH
button to start,
When activated the relevant indicator is on.
Follow the Pods manufacturer's dosage and
storage recommendations.
Put maximum two tablets or single-dose
detergents in the PODS® compartment in the
detergent dispenser drawer.
The option remains active also for next cycles
until it is deactivated and if it is selectable
with the set programme.
7.7 Plus Steam
This option adds a steam phase followed by a
short anti-crease phase at the end of the
washing programme.
The steam phase reduces fabric creasing and
facilitates the fabric ironing.
The Plus Steam option achieves good results
with a small load because steam better
penetrates the laundry if there is more space.
For this reason, the programme maximum
load combined with this option is 2 kg
(approximately 8 - 10 shirts).
When setting the Plus Steam option, the
maximum load drops to 2 kg in the display
and programme time is adjusted accordingly.
The indicator blinks in the display during
steam phase.
This option can affect the programme
duration.
When the programme stops the display
shows a zero , the indicator
on.
The anti-crease phase starts, the indicator
is blinking, and the Start/Pause
remains lit. The drum performs smooth
movements for about 30 minutes to keep the
steam benefit.
To interrupt the anti-crease phase, you can:
• Press the On/Off
seconds to activate or the deactivate the
appliance.
• Turning the programme dial in another
position.
is steady
led
button for a few