Table of Contents
Advertisement
DETAILEDCHANNELSETTINGS
Antennasettingsfordigital
satellitechannelsandsearching
forchannelsautomaticallywith
SCRsystem
Notes:
Your TV supports SCR system (Single
7
Channel Router). SCR (Single Channel
Router - EN 50494).
LNB settings described in the following
7
section require significant expertise on
satellite systems. Contact your authorised
dealer about this matter.
1
Press »
«.
>
2
Press »
« to select »Settings«.
3
Press »
« then »
V
confirm with »
– » LIVE TV« menu will be displayed.
4
Confirm »Channel Scan« with »
– » Please make sure your antenna is setup
and plugged into your device« will be
displayed.
5
Confirm »Next« with »
6
Press »
« or »
V
Λ
press »
« to confirm.
7
Press »
« or »
V
Λ
press »
« to confirm.
8
To delete the previously saved channels and
search, select »Yes«;
or
to continue searching without deleting the
channels, select »No, keep existing« and
press »
« to confirm.
9
Press »
« or »
V
Λ
»
« to confirm.
10
Press »
« or »
V
Λ
want to search from the list and press »
to confirm.
– » Satellite Connection« will be displayed.
80
ENGLISH
>
« to select »Live TV« and
«.
«.
«.
« to select the country and
« to select »Satellite« and
« to select »Full« and press
« to select the satellite you
----------------------------------------------------
11
Press »
V
press »
12
Press »
V
»
« or »
§
that is being used.
13
Press »
V
confirm with »
14
For band frequency, press »
or »
« to select the required numbers and
Λ
press »
Enter the frequency and press »
select »Next«.
Notes:
Use installation equipment supported /
7
suggested by your SCR Switch.
Other users / receivers connected to the
7
system may be affected if the specified user
band number and frequency are changed
during installation.
User band and User band frequency are
7
specified on the SCR switch used; and each
user / receiver must select a specified user
band and user band frequency.
With SCR satellite system, auto search by
7
several users / receivers at the same time
may cause problems.
15
Press »
V
»
« or »
§
For free digital TV channels only, select
(Free); for paid digital TV channels, select
(Scrambled); for both, select (All).
16
Press »
8!
– » Search« menu will appear and channel
search will start.
– C hannel search will take some time
depending on the number of the channels
to be searched.
17
Confirm »Done« with »
«
setting process and display the Home menu.
« to select »Single Cable« and
« to set it to »ON«.
« to select »User Band« and press
« to select the antenna socket
$
« to select »Band Frequency« and
«.
<
«, »
« to move to the next character.
« to select »Scan Mode« and use
« to select the scan mode.
$
« to start searching.
« to complete the
>
«, »
«
V
« to
8!
Advertisement
Table of Contents
