Wired Network Settings - Grundig 32 VLE 6020 User Manual

NETWORK­SETUP
Wired­network­settings
There are two ways of making the wired
network settings.
A Automatic connection,
a ll data regarding connection settings
(»IP Address«, »Netmask«, »Gateway«
and »DNS«) are obtained from modem
automatically.
B Manual connection,
a ll data regarding connection settings (»IP
Address«, »Netmask«, »Gateway« and
»DNS«) must be configured manually.
Automatic­connection
Most home networks are Dynamic Networks.
If you have a dynamic network, you must use
a DSL modem that supports DHCP. Modems
and IP sharers that support DHCP obtain the »IP
Address«, »Netmask«, »Gateway« and »DNS«
values required for internet access automatically,
and thus you are not required to enter those
values manually. Your TV will automatically
connect to the network.
Note:
If you do not have a dynamic network,
7
follow the instructions in manual connection
section.
70­ ENGLISH
­ - ------------------------------------------------------------------------------------------
Manual­connection
Certain networks require a Static IP address.
If your network requires a Static IP address,
you must enter the »IP Address«, »Netmask«,
»Gateway« and »DNS« values manually. You
can get »IP Address«, »Netmask«, »Gateway«
and »DNS« values (ISS) from your Internet
Service Provider.
1­
Press »
2­ Press »
3­
Press »
and confirm with »
– » NETWORK« menu will be displayed.
4­ Confirm »Configure Network« with »
5­
Enter the IP address. Press »
or »
press »
6­ Press »
7­
Enter the Network Prefix Length. Press
<
»
required character or press »
the next character.
8­ Press »
9­ Enter gateway address. Press
<
»
required character or press »
the next character.
10­ Press »
11­ Enter DNS 1 address. Press
<
»
required character and press »
to the next character.
12­
Press »
«.
>
« to select »Settings«.
>
« then » « to select »Network«
V
 «.
NETWORK
Configure Network
Network
« to select the required character and
Λ
 « to move to the next character.
« to select »Next«.
8!
>
«, » «, » « or » « to select the
V Λ
« to select »Next«.
8!
>
«, » «, » « or » « to select the
V Λ
« to select »Next«.
8!
>
«, » «, » « or » « to select the
V Λ
« to select »Next«.
8!
Wired (Connected)
Press SELECT to manually
configure your Ethernet
connection.
Check network status.
unplug your network cable to
connect to Wi-Fi
«.

< >
«, » «, » «
V
 « to move to
 « to move to
 « to move