System Menu (System); Nap Timer (Nap Function) - Silvercrest SRH 5 C3 Operating Instructions And Safety Instructions

♦ Turn the VOLUME |
lowest volume level .
♦ Plug the jack plug of the headphones into the headphone socket
on the rear of the device . Sound playback now takes place only via the
connected headphones .
♦ Set the desired volume using the VOLUME |

System menu (System)

NOTE
► The system menu can be called up during operation and also in standby
mode .
► If no setting is made in the system menu within 20 seconds, the device exits
the settings menu .
♦ Press the INFO/MENU button
♦ Press the TUNE+
turn the VOLUME |
the display
♦ Press the VOLUME |

Nap timer (NAP function)

Using the NAP function, you can set a timer alarm that will wake you up with an
alarm signal after 1–120 minutes .
Setting the nap timer
♦ Call up the system menu . The first menu item to appear is the NAP timer .
♦ Press the VOLUME |
♦ Press the TUNE+
between 001 and 120 minutes .
♦ Press the VOLUME |
and start the nap timer . After exiting the system menu, N appears on the
display
SRH 5 C3
ENTER / SCAN dial
or TUNE−
8
ENTER / SCAN dial
.
1
ENTER / SCAN dial
ENTER / SCAN dial
or the TUNE− button
8
ENTER / SCAN dial
6
ENTER / SCAN dial
followed by the remaining minutes or seconds .
1
anticlockwise to the
6
ENTER / SCAN dial
for approx . 2 seconds .
4
button (several times if necessary) or
7
until System appears on
6
to confirm the selection .
6
to confirm the selection .
6
or turn the VOLUME |
7
to set the alarm time in 1-minute steps
to confirm the selection
6
GB │ IE │ NI
e
.
6
25 ■
│