Table of Contents
Advertisement
Blade Service (continued)
1. Install the blade as shown.
Note:
pointing upward toward the inside of the
mower to ensure proper cutting.
2. Torque the blade bolt to 136 to 149 N·m (100
to 110 ft-lb).
Leveling the Mower Deck
Ensure that the mower deck is level any time you install the mower deck or when you see an
uneven cut on your lawn.
Preparing to Level the Mower Deck
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operating position.
3. Ensure that the tires are inflated to the correct specifications and the caster wheels are
facing straight forward.
4. Check the mower deck for bent blades; remove and replace any bent blades.
5. Raise the mower deck to the 76 mm (3 inch) height-of-cut setting.
Checking the Mower-Deck Level
1. Position the blades side-to-side.
2. Measure at locations
surface to the cutting edge of the blade tips
The difference between the measurements
should be no more than 5 mm (3/16 inch). If
the measurement is larger, adjust the side-to-
side level.
Maintenance: Mower-Deck Maintenance
The curved part of the blade must be
and
G451425
position.
ARK
from a level
.
G414698
Page 5–27
3464-659 A
Advertisement
Table of Contents
