TP-Link TD-W8910G User Manual page 77

To add the IP Address:
1. Click the Add button. You can add a new IP Address in the next screen (shown in Figure
4-78).
2. Enter the IP address of the management station permitted to access the local management
services.
3. Click the Save/Apply button to save the IP Address.
4. Enable the Access Control Mode (shown in Figure 4-77).
Note:
If Enabled, the Router will permit access to local management services from IP addresses
contained in the Access Control List. If the Access Control mode is Disabled, the function will not
validate, and all IP addresses can access to local management services. The services are the
system applications listed in the Service Control List.
4.7.5.3. Passwords
Choose "Management" "Access Control" "Password", you can see the screen (shown in
Figure 4-79) which allows you to change the factory default password of the Router.
TD-W8910G 54M Wireless ADSL2+ Router User Guide
Figure 4-77
Figure 4-78
70