TP-Link TD-W8910G User Manual page 29

2. PPPoE
If you choose PPPoE in the previous screen (shown in Figure 4-5), the configuration is
similar to PPPoA, the only difference is that you should set the PPPoE Service Name on
the corresponding screen. You can refer to Chapter 4 to achieve the configuration for the
connection type.
3. MER
If you choose MER in the previous screen (shown in Figure 4-5), you can see the screen
(shown in Figure 4-9). Follow the instructions to configure the connection.
1) Configure the WAN IP Address. If you are provided a dynamic IP Address, please select
obtain an IP address automatically, and then the Router will automatically get IP
parameters from your ISP. If you are provided with a static IP Address, please select Use
the following IP Address, and then enter the WAN IP Address and WAN Subnet
Mask.
2) Configure the default gateway. If you are provided a dynamic gateway address, please
select obtain default gateway automatically, and then the Router will automatically get
TD-W8910G 54M Wireless ADSL2+ Router User Guide
Figure 4-9
22