Cisco Catalyst IW9165D Hardware Installation Manual page 35

Heavy duty access point

Table of Contents

Installation Overview

Step 2

Connect the supplied ground lug to the access point ground connection point using the supplied screws. Apply supplied

oxide inhibitor between the ground lug and the access point ground connection.

AP ground connection point

M4 screws (x2)

Step 3

Tighten the screws to 10-15 inch-lbs of torque.

Step 4

If necessary, strip the other end of the ground wire and connect it to a reliable earth ground such as a grounding rod or

appropriate ground point on a grounded pole. Length of the ground cable should not exceed 1 meter, and 0.5 meter is

preferred. Use supplied oxide inhibitor on the grounded interface.

2 2

Cisco Catalyst IW9165D Heavy Duty Access Point Hardware Installation Guide

Grounding the Access Point

Grounding lug

Table of Contents

Chapters

Table of Contents