Personal/Altitude Adjustment Setting - Suunto Favor Air User Manual

27
The Dive History is activated by touching the TIME/MODE and COM contacts until HIS
appears. This mode will show:
- the maximum depth ever reached
- the total number of dives
- the total accumulated dive time in hours
999 dives and 999 hours of diving can be registered. When these maximum values are
reached, the counters will start again from 0.
NOTE: The maximum depth will be zeroed, if the depth of 97.6 m [320 ft] is exceeded.
NOTE: The dive and dive time counters in the History Memory contain some test dives
made in the factory (e.g. DIVE 2, DIVE TIME 1 h). The maximum depth is, however,
zeroed.

4.3 PERSONAL/ALTITUDE ADJUSTMENT SETTING

The current personal/altitude adjustment mode is shown when diving as well as on the
surface display. If the mode does not match the altitude or conditions (see Chapter 3.6),
it is imperative that the diver enter the correct selection before diving.
The new personal/altitude adjustment setting is entered in the following way. In these
figures the contacts which are connected are highlighted.
1. Activate the personal/altitude adjustment setting mode by connecting the
TIME/MODE and COM contacts continuously. Release your fingers immediately when
Alt is pointed on the display. Within a couple of seconds the present personal/altitude
adjustment setting is shown.
2. Connect the PLAN/ON and COM contacts until all three personal/altitude adjustment
modes appear. Release your fingers immediately at this point. The current mode is now
blinking. Wait at least two seconds but not more than four seconds before the next step.
3. Connect again the PLAN/ON and COM contacts until the blinking personal/altitude
adjustment mode starts to scroll. Release your fingers when the desired mode is
blinking. Wait at least two seconds but not more than four seconds before the next step.
4. Connect the TIME/MODE and COM contacts to confirm this new personal/altitude
adjustment mode. The blinking will stop and the other mode indicators will disappear.
5. The process is ended by the RETURN command, i.e. by connecting all three contacts
at the same time. The FAVOR AIR will return to the surface mode.
WARNING!
ALWAYS RECHECK THE PERSONAL/ALTITUDE ADJUSTMENT SETTING TO
ENSURE THAT IT IS NOT SET FOR AN ALTITUDE LESS THAN THAT OF THE DIVE