At The Surface; Surface Interval - Suunto Favor Air User Manual

20
Display Above Ceiling
If you ascend above the ceiling, a downward pointing arrow will appear and a
continuous beeping starts. In addition, a blinking error warning Er reminds you that you
have only three minutes to correct the situation. You must immediately descend to or
below the ceiling.
If you continue to violate the decompression requirements, the FAVOR AIR goes into a
permanent ERROR MODE. In this mode you must not dive again for at least two days.
See also Section 3.7, "Error Conditions".
WARNING !
NEVER LET THE CEILING DEPTH DESCEND DEEPER THAN 9 m [30 ft]!
When the ceiling is deeper than 9 m [30 ft], a blinking error warning Er will appear and
when the 12 m [39 ft] ceiling is reached the FAVOR AIR will go into a permanent error
mode.
WARNING!
ALWAYS COMPARE THE ASCENT TIME TO THE REMAINING AIR TIME AND AIR
PRESSURE!
It is important that you have sufficient air to make proper decompression stops.

3.5 AT THE SURFACE

3.5.1 Surface Interval

An ascent to any depth shallower than 1.8 m [6 ft] will cause the DIVING display to be
replaced by the two SURFACE displays, giving the following information:
Display I
- The surface time in hours and minutes (separated by a colon), telling the duration of
the present surface interval. It is shown above SURF TIME in the center window of the
display.
- The dive time in minutes, i.e. the total duration of the most recent dive, is displayed
next to DIVE TIME in the lower left corner.
- The maximum depth of your most recent dive in meters [ft] is shown in the same
position as your depth readings during the dive. The MAX indicator is then shown next
to the value. The SLOW warning will blink over the maximum depth, if you have surfaced
with the SLOW warning on.
- The no-flying warning is indicated by a blinking airplane.
- The present cylinder pressure in bars [psi].
Display II
- The present depth in meters [ft].