Dive Planning - Suunto Favor Air User Manual

Table 3.1 Battery Power Indicator
Battery Voltage
over 3.4 V
3.4 V ... 3.2 V
3.2 V ... 3.0 V
less than
3.0 V
After activation the Low Battery Warning is indicated by the battery symbol.
If the battery symbol is displayed in the surface mode or if the display is faded or weak,
the FAVOR AIR should not be used. It indicates that the battery is too low to operate the
FAVOR AIR. If the low battery symbol appears during a dive, you should abort the dive
and begin ascent to the surface.
NOTE: The backlite can not be activated, when the low battery warning is indicated by
the battery symbol.
NOTE: Temperature affects the battery voltage. If the FAVOR AIR is stored at
temperatures below freezing point, the low battery warning may be displayed even
though the battery has enough capacity in warmer conditions. Make sure that the low
battery warning disappears before diving.

3.3.2 Dive Planning

It is possible at any time on the surface to enter the DIVE PLANNING mode, simply by
touching the PLAN/ON and COM contacts. The display will rapidly cycle through the
no-decompression limits for various depths from 9 m [30 ft] to 45 m [150 ft] in 3 m [10 ft]
increments. It takes about 45 seconds to run through the complete cycle, after which the
FAVOR AIR will automatically return to the READY display.
Display after
activation
upward pointing
segment
horizontal segment
downward pointing
segment + LOW
lowest segment +
LOW
Operation
normal
battery change is
recommended
don´t dive, change the
battery
don´t dive,
after three more
activations the
computer stays
deactivated until the
battery has been
replaced
Note
light not available
+ battery symbol
light not available
+
battery symbol
13