Agency Compliance; Usa Federal Communications Commission Statement; European Union Directive Conformance Statement - Dell PowerSwitch S4128F-ON Installation Manual

Table of Contents

Advertisement

Agency compliance

The S4100–ON Series (S4128F-ON, S4148F-ON, S4148FE-ON, S4128T-ON, S4148T-ON, and S4148U-ON) switch complies with
the following safety and agency requirements:

USA Federal Communications Commission statement

This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
rules. These limits are designated to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy. If it is not installed and
used in accordance to the instructions, it may cause harmful interference to radio communications. Operation of this equipment
in a residential area is likely to cause harmful interference, in which case users will be required to take whatever measures
necessary to correct the interference at their own expense.
Properly shielded and grounded cables and connectors must be used in order to meet FCC emission limits. Dell is not responsible
for any radio or television interference caused by using other than recommended cables and connectors or by unauthorized
changes or modifications in the equipment. Unauthorized changes or modification could void the user's authority to operate the
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Figure 29. Canadian department of communication statement

European Union directive conformance statement

This product is in conformity with the protection requirements of EU Council Directive 2004/30/EC on the approximation of the
laws of the Member States relating to electromagnetic compatibility. Dell cannot accept responsibility for any failure to satisfy
the protection requirements resulting from a nonrecommended modification of this product, including the fitting of non-Dell
option cards.
This product has been tested and found to comply with the limits for Class A Information Technology Equipment according
to CISPR 32/CISPR34 and EN55032/EN55034. The limits for Class A equipment were derived for commercial and industrial
environments to provide reasonable protection against interference with licensed communication equipment.
NOTE:
This is a Class A product. In a domestic environment, this device may cause radio interference, in which case, you
may be required to take adequate measures.
European Community Contact
Dell, EMEA - Central
Dahlienweg 19
66265 Heusweiler
Germany
Tel: +49 172 6802630
Email: EMEA Central Sales
Specifications
45

Advertisement

Table of Contents
loading

Table of Contents