Compact Flash Card Pwr Connector; Sgpio Headers - Supermicro X7DB8 User Manual

Compact Flash Card PWR
Connector
A Compact Flash Card Power
Connector is located at JWF1. For the
Compact Flash Card or the Compact
Flash Jumper (JCF1) to work properly,
you will need to connect the Compact
Flash Card power cable to JWF1 fi rst.
Refer to the board layout below for
the location.

SGPIO Headers

There are two SGPIO (Serial General
Purpose Input/Output) headers (J29,
J30) located on the motherboard. These
headers support serial link interfaces for
the onboard SATA and SAS connectors.
See the table on the right for pin
defi nitions. Refer to the board layout
below for the location.
GLAN1
GLAN2
SIMLP IPMI
SEPC
PCI-Exp x8
PCI-Exp x4
Compact Flash Card PWR
Jumper Defi nition
On
Off
Pin# Defi nition
1 *NC
3 Ground
5 Load
7 *NC
Note: NC= No Connections
8-pin PWR
SMB PS PSF
J3P
JAR
A
SCSI CTRL
320 SCSI Channel B
2-23
Chapter 2: Installation
Connector
Compact Flash
Power On
Compact Flash
Power Off
SGPIO
Pin Defi nitions
Pin Defi nition
2 *NC
4 Data
6 Ground
8 *NC
A. Compact Flash PWR
B. SGPIO1
B. SGPIO2
C
B