Table of Contents
Advertisement
Available languages
Available languages
Booster function
When active, this function temporarily
boosts the power output of a specific
cooking zone. You can set the heat set-
ting in the range from 1 to P, where P the
highest possible heat setting.
Note! The Booster function can only
operate for a maximum of 5 minutes
and then heat setting is automatically
reduced to level 9.
To deactivate the Booster earlier, adjust
the heat setting down with the (–) Lower
heat setting or touch both the (+) Higher
heat setting and (–) Lower heat setting
sensors.
Child Lock
To activate Child Lock, touch
appliance is on. When the Child Lock is
active, you can only use the
To deactivate the Child Lock touch and
hold the Child Lock sensor again.
Cooking zone auto off
The cooking zone will turn off automati-
cally after a specified time has elapsed,
which depends on its heat setting. This is
a safety feature that cannot be disabled.
Heat setting
1-3
4-6
7-9
Minute Minder
Minute Minder can be set from 1 to 99
minutes. To use it, make sure that at
least one cooking zone is active. Use
and
to adjust the duration and
countdown will start after a few seconds.
When countdown completes, you will
hear a beep.
To deactivate Minute Minder, use
to reduce duration down to 00 or touch
both the
and
ously.
while the
sensor.
Shutdown time
(hours)
8h
4h
2h
sensors simultane-
Set cooking zone Timer
You can set the cooking zone to turn off
after a specific time. To do this, select
the desired cooking zone and set its
heat setting. While the heat setting is
still flashing, use the
to adjust the duration, and countdown
will start after a few seconds. The active
timer is indicated by a dot on the display.
When countdown completes, the cook-
ing zone will deactivate. You can set the
Timer time for each cooking zone.
To deactivate Timer for a selected
cooking zone, select the cooking zone,
use
to reduce duration down to 00
or touch both the
simultaneously.
Double cooking zone
The cooking zone on the right has two
independent induction rings. The appli-
ance will use the correct induction ring
for the diameter of the pot you place on
the cooking zone.
Error Codes
The appliance indicates some problems,
which you can remove by yourself:
E3 - elevated glass temperature. Turn off
the appliance and wait for it to cool down
E7 - power supply voltage too low
E8 - power supply voltage too high
For other errors, please contact the man-
ufacturer's service centre or the retailer.
and
sensors
and
sensors
55
Advertisement
Table of Contents
