Table of Contents
Advertisement
G010233
3
1
1. Anti-scalp roller
2. Bolt
Positioning the Seat
While sitting in the operator's position, raise the
seat-adjustment lever slightly, and move the seat forward or
backward to the desired position (Figure 22).
G014969
1. Seat-adjustment lever
4
2
Figure 21
3. Flange nut
4. Hole spacing
1
Figure 22
Adjusting the Motion-control
Levers
Adjusting the Height
The motion-control levers can be adjusted higher or lower for
maximum operator comfort.
1. Remove the 2 bolts holding the control lever to the
control-arm shaft (Figure 23).
2. Move the control lever to the next set of holes.
3. Secure the lever with the 2 bolts (Figure 23).
G014970
1. Control-arm shaft
2. Control lever
4. Repeat the adjustment for the opposite control lever.
Adjusting the Tilt
The motion-control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to the
control-arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever fore or aft (Figure 23).
Note: Tighten both bolts to secure the control in the
new position.
3. Repeat the adjustment for the opposite control lever.
20
2
1
3
4
Figure 23
3. Slotted, upper hole
4. Bolt
Advertisement
Table of Contents
