Toro 74643 Operator's Manual page 39

3
2
1
5
Figure 58
1. Rod
2. Spring
3. Deflector
2. Position the new discharge deflector with the bracket
ends between the welded brackets on the deck as
shown in Figure 58.
3. Install the spring onto the straight end of the rod.
Note: Position the spring on the rod as shown in so
the shorter spring end is coming from under the rod
before the bend and going over the rod as it returns
from the bend.
4. Lift the loop end of the spring and place it into the
notch on the deflector bracket (Figure 59).
4
g017617
4. Deck brackets
5. Spring installed over the
rod
1. Rod and spring assembly
installed
2. Loop end of the spring
installed into the notch in
the deflector bracket
5. Secure the rod and spring assembly by twisting it so the
short end of the rod can be placed behind the front
bracket welded to the deck (Figure 59).
Important: The grass deflector must be spring
loaded in the down position. Lift the deflector up
to test that it snaps to the full down position.
39
2
1
3
4
g017618
Figure 59
3. Rod, short end, moved
behind mower bracket
4. Short end, retained by the
mower bracket