Canon MAXIFY GX2000 Series Online Manual page 178

Note
• When Reduce is selected, V.34 (Super G3) can not be used. Communication time generally •
becomes longer than when communicating with V.34 (super G3).
• • This setting has priority even if you select 33600 bps for TX start speed or RX start speed.
• Auto redial •
Enables/disables automatic redialing.
If you select ON, you can specify the maximum number of redial attempts and the length of time the
printer waits between redial attempts.
• • Dial tone detect
Avoids mistransmission when reception and transmission occur at the same time.
If you select ON, the printer transmits the fax after confirming the dial tone.
Note
• This setting may not be available depending on the country or region. •
• • Pause time settings
Sets the length of pause time for each when you enter "P" (pause).
• • TTI position
Selects the printing position of the sender information (outside or inside the image area).
• • Remote RX
Enables/disables remote reception.
If you select ON, you can specify the remote reception ID.
Remote Reception
• • Color transmission
When faxing color documents using the ADF, selects whether to convert them into black & white data
if the recipient's fax device does not support color faxing.
If you select Disconnect, the printer does not send color documents when the recipient's fax device
does not support color faxing.
• RX image reduction •
Enables/disables automatic reduction of incoming faxes so that they fit in the selected paper.
If you select ON, you can select the image reduction direction.
• Adv. communication settings •
◦ ◦ ECM TX
Selects whether to send faxes in Error Correction Mode (ECM).
Transmission/Reception of Faxes Using ECM
◦ ECM RX ◦
178