How To Remove Misfeeds - Sharp DX-C311 Operation Manual

HOW TO REMOVE MISFEEDS

If you require more information when reading the instructions in the touch panel, see the paper misfeed illustrations
below. Refer to the illustration below and then go to the appropriate illustration (1 to 10) for your situation.
☞
(1): page 8-3, (2)-(8): page 8-4, (9)-(10): page 8-5
When removing a misfeed or closing a cover, tray, or the finisher, take care that your fingers do not become pinched.
(1) Original misfeed
Paper
feed roller
After removing the misfeed, open and close the
automatic document feeder (or the document feeding
area cover or document feeder tray) to clear the
misfeed display from the touch panel.
(1) (2) (3)
(8) (9)
Open the document feeder
cover and remove the paper
feed roller.
If it is difficult to remove
misfed paper, remove the
paper feed roller. To remove
the paper feed roller, see
"Removing the paper feed
roller".
Pull out the document feeder
tray and remove the misfed
paper.
Open the automatic
document feeder and
remove the original.
(10)
(4)
(5)
(6), (7)
Removing the paper feed roller
• If the roller cover is not pointing straight up when
the shaft is removed, a failure may occur.
• Carefully pull the misfed paper out without tearing it.
8-3
TROUBLESHOOTING
Lift up the knob that holds
the roller shaft.
Pull down the release lever.
Remove the shaft rotating
the roller cover upward and
remove the shaft.
Contents