Oki ES8462 User Manual page 56

FEATURE OPTION
Network Network
Menu (cont.) Setup
(cont.)
Subnet Mask xxx.xxx.xxx.xxx
Gateway xxx.xxx.xxx.xxx
Address
Web Disable, Enable
Telnet Disable, Enable
FTP Disable, Enable
Disable, Enable
IPSec
SNMP Disable, Enable
Network Scale Small, Normal
Auto Negotiate,
HUB Link
Setting 100BASE-TX FULL,
100BASE-TX HALF,
10BASE-T FULL,
10BASE-T HALF
Network PS- ASCII, RAW
Protocol
Execute
Factory Defaults
Configuring your machine... > 56
DESCRIPTION
Current assigned subnet mask. To
change, proceed as above.
Display condition: TCP/IP protocol
must be enabled.
IP version must be IPv4 or
IPv4+IPv6.
Current assigned gateway
address. To change, proceed as
above.
Display condition: TCP/IP protocol
must be enabled.
IP version must be IPv4 or
IPv4+IPv6.
Enables or disables web config.
facility.
Display condition: TCP/IP protocol
must be enabled.
Enables or disables Telnet config.
facility.
Display condition: TCP/IP protocol
must be enabled.
Enables or disables communication
via FTP.
Display condition: TCP/IP protocol
must be enabled.
Enable via the web page or
Configuration Tool.
Enables or disables SNMP of FTP
(TCP/IP or NetWare).
Display condition: TCP/IP protocol
must be enabled.
Normal: Can work effectively even
when connected to a HUB that has
a spanning tree feature. However,
printer start up time gets longer
when computers are connected to
two or three small LANs.
Small: Computers can cover from
two or three small LANs to a large
LAN, but it may not work
effectively when it is connected to
a HUB with a spanning tree
feature.
Sets the hub linking method.
Select PostScript data format for
the network port.
Select Yes to reload the settings
present when the unit was setup
by the manufacturer.