Sharp XE-A302 Instruction Manual page 13

This is not factory preset. You must enable this function.
• Foreign currency conversion rate
You must set a conversion rate to use
• Preset unit price for departments
• Preset amount for
% &
• Preset rates for
You do not have to program these preset prices/amount/rates since they can be entered at
registration. It might be convenient to preset so you do not have to re-enter every time.
• Amount entry digit limit for PO amount, RA amount, Manual tax amount
The factory setting makes the maximum amount you can enter. You can program to limit the amount.
• Sentinel - High amount lockout (HALO) for cash in drawer (CID)
• Department group
You can classify departments into a maximum of 9 groups (0 to 9 groups: 0: non-group is assigned).
Sales in each group can later be printed on an individual group total report and full group total report.
• Commission
If you program commission rates (up to two) and classify departments and PLUs/subdepartments into
commission groups (0 to 2 groups: 0: non-commission), commission sales and amount in each
commission group can later be printed on individual and full clerk reports.
• Key sequence for AUTO key
• RS-232C programming
• Specification of clerk to be trained
Department programming:
The cash register is pre-programmed for departments as follows:
Department: Allow open price entry in normal department (group: 0, commission group: 0), taxable status-
taxable 1 for department 1 to 6, and non taxable for department 7 to 99
When you use department 7 or above, and/or you apply taxable status other than taxable 1 for department 1 to
6, you must change department settings. Please refer to the
details.
PLU/subdepartment programming:
The cash register is preprogrammed for PLUs/subdepartments as follows:
PLU/subdepartment selection: PLU is selected for all PLU codes so that you only have to program unit prices
and associated departments for them (by default, unit price is set to 0 and associated department is set to
department 1). Function parameters including tax status depend on the status of associated department.
• For direct PLU keys, PLU codes 1 through 75 are assigned for PLU 1 through 75 keys respectively.
6
Starting sales entries
Now you are ready for sales registration.
-
V
key.
department programming section for programming
11