Table of Contents
Advertisement
To install the plastic rear vent and fin, reverse this procedure.
Display assembly
To remove and disassemble the display assembly, use these procedures and illustrations.
NOTE:
You can remove the bezel, display panel, and camera module without removing the entire display
assembly from the computer. For more information, see
display) on page
Full hinge-up displays are not available as spare parts. Spare parts for displays are available only at the
subcomponent level.
Before removing the display assembly, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
4.
Remove the fan assembly (see
5.
Remove the I/O board bracket (see
6.
Remove the system board with heat sink installed (see
7.
Remove the plastic rear vent and fin (see
Remove the display assembly:
1.
Open the display to open the hinges (1).
2.
Remove the eight Phillips M2.6 × 4.5 screws (2) that secure the display assembly to the computer.
3.
Separate the display from the computer (3).
4.
If you need to remove the bezel:
a.
Flex the top (1), the left and right sides (2), and then the bottom of the bezel (3) to release it.
58
Chapter 6 Removal and replacement procedures for authorized service provider parts
40. You do have to remove the display assembly to remove the remaining subcomponents.
Bottom cover on page
Battery on page
Fan assembly on page
I/O board on page
Display subcomponents (without removing the
Preparation for disassembly on page
37).
39).
46).
48).
System board on page
Plastic rear vent and fin on page
37).
52).
56).
Advertisement
Table of Contents
