HP Victus Maintenance And Service Manual page 63

1. Prepare the computer for disassembly (see
2. Remove the bottom cover (see
3. Remove the battery (see
4. Remove the fan assembly (see
5. Remove the system board with heat sink installed (see
Remove the plastic rear vent and fin:
1. Remove the four Phillips 2.0 × 2.0 broadhead screws (1) that secure the fin to the computer, and then
remove the fin (2).
2. Remove the four Phillips M2.0 × 2.0 broadhead screws (1) and two Phillips M2.0 × 2.5 screws (2) that
secure the plastic rear vent to the computer, and then remove the vent (3).
Preparation for disassembly on page
Bottom cover on page
Battery on page 39).
Fan assembly on page
37).
46).
System board on page
Plastic rear vent and fin
37).
52).
57