HP Armada e500 Series Appendix

B
appendix
P C
OWER
R
EQUIREMENTS

3-Conductor Power Cord Set

The wide range input feature of the Armada E500 and V300 Series of
Personal Computers permits them to operate from any line voltage from
100 to 120 or 220 to 240 volts AC.
The power cord sets received with the computers meets the requirements
for use in the country where the equipment is purchased.
Power cord sets for use in other countries must meet the requirements of
the country where the computer is used. For more information on power
cord set requirements, contact a Compaq authorized reseller or service
provider.

General Requirements

The requirements listed below are applicable to all countries:
1. The length of the power cord set must be at least 5.00 feet (1.5 m) and
a maximum of 6.50 feet (2.0 m).
2. All power cord sets must be approved by an acceptable accredited
agency responsible for evaluation in the country where the power
cord set will be used.
3. The power cord set must have a minimum current capacity of 10A
and a nominal voltage rating of 125 or 250 volts AC, as required by
each country's power system.
4. The appliance coupler must meet the mechanical configuration of an
EN 60 320/IEC 320 Standard Sheet C13 connector, for mating with
appliance inlet on the back of the computer.
S
ORD ET
Connector Pin Assignments B-1