Table of Contents
Advertisement
installation-panels, barriers, faceplates
5. Pull the 3 lower glass gasket pads forward to release the glass.
6. Support the glass with one hand and open the 9 lower clamps.
Lower clamps (x9) in open position
7. Locate the 2 levers below the glass and turn them both 90° in a
3RD ANGLE
TOLERANCES UNLESS
PROJECTION
OTHERWISE STATED
clockwise direction to lower the firebox glass panel.
DIMENSIONS
0.000 = 0.01 CRITICAL
0.000 = SPECIFIED TOLERANCE
DO NOT SCALE
0.000 = 0.031
DRAWING
0.000 REF = REFERENCE ONLY
UNITS IN INCHES
ANGULAR = 1
THIS DRAWING IS THE PROPERTY OF FPI LTD., IT MAY NOT BE COPIED IN WHOLE OR IN PART, OR DISCLOSED TO A THIRD PARTY WITHOUT OUR PRIOR WRITTEN CONSENT.
Levers to lower firebox glass
3RD ANGLE
PROJECTION
DO NOT SCALE
DRAWING
UNITS IN INCHES
70
| City Series CP60E
Gasket pad
FIREPLACE PRODUCTS
INTERNATIONAL
1:24
SCALE:
MEDRALIN
DWN:
E.C.N.:
TOLERANCES UNLESS
FIREPLACE PRODUCTS
OTHERWISE STATED
INTERNATIONAL
DIMENSIONS
0.000 = 0.01 CRITICAL
1:24
SCALE:
0.000 = SPECIFIED TOLERANCE
0.000 = 0.031
MEDRALIN
DWN:
DATE:
0.000 REF = REFERENCE ONLY
ANGULAR = 1
E.C.N.:
SIGN:
THIS DRAWING IS THE PROPERTY OF FPI LTD., IT MAY NOT BE COPIED IN WHOLE OR IN PART, OR DISCLOSED TO A THIRD PARTY WITHOUT OUR PRIOR WRITTEN CONSENT.
Push down on levers to lower glass panel
8. Carefully lean glass forward onto support.
• The firebox glass may remain propped on the glass supports to
clean the interior surface. Use care when cleaning -- do not apply
excessive force or pressure.
9. To remove the firebox glass panel from the unit, tilt the glass forward
-
gently onto the glass supports, grip both suction clamps and lift the glass
MAT'L :
SHEAR/ PUNCH/ FORM
up and out of the unit.
PROCESS :
CP60 MAIN ASSEMBLY
PART :
10. To install glass--reverse steps.
11/23/2021
PART NO:
DATE:
457-500
SIGN:
DATE:
• Remove glass panel completely when installing or
removing panels, logs, media, etc. to avoid causing
any damage to the glass.
-
MAT'L :
SHEAR/ PUNCH/ FORM
PROCESS :
CP60 MAIN ASSEMBLY
PART :
11/23/2021
PART NO:
REV:
457-500
-
DATE:
Glass panel--leaning on support
3RD ANGLE
TOLERANCES UNLESS
PROJECTION
OTHERWISE STATED
DIMENSIONS
0.000 = 0.01 CRITICAL
0.000 = SPECIFIED TOLERANCE
DO NOT SCALE
0.000 = 0.031
DRAWING
0.000 REF = REFERENCE ONLY
UNITS IN INCHES
ANGULAR = 1
THIS DRAWING IS THE PROPERTY OF FPI LTD., IT MAY NOT BE COPIED IN WHOLE OR IN PART, OR DISCLOSED TO A THIRD PARTY WITHOUT
REV:
-
FIREPLACE PRODUCTS
-
MAT'L :
INTERNATIONAL
SHEAR/ PUN
PROCESS :
1:24
CP60 MAIN ASS
SCALE:
PART :
11/23/2021
MEDRALIN
PART NO:
DWN:
DATE:
457-50
E.C.N.:
SIGN:
DATE:
Advertisement
Table of Contents
