Using On Slopes; Operation - Stiga MPST 84 Li 48 V1 Operator's Manual

Status
Machine ON and Operating.
Machine ON and Operating.
DANGER
If any results do not to match the indications
in the tables, do not use the machine!
Contact an Authorised Service Centre to
have it checked and repaired if necessary.
NOTE
Always bear in mind that the safety devices
prevent the electric engine from starting if safety
requirements have not been met. In such cases,
once start-up consent has been reset, remove
the key before starting the machine again.

7.3 USING ON SLOPES

Comply with the limits indicated in the
"Technical Data" Tables as in "fig. 18"
regardless of the mowing direction.
Remember there is no such thing as a "safe"
slope. Driving on grass slopes requires
particular care. To prevent overturning
or loss of control over the machine:
• Never mow across the face of the slope.
Lawns on slopes must be mowed by moving
up and down and never across them in
forward gear. When changing direction,
take great care that the wheels facing the
slope do not hit any obstacles (such as
stones, branches, roots, etc.) that may
cause the machine to slide sideways,
tip over or make you lose control.
• Do not stop or start suddenly
when going up or downhill;
• Shift to drive gear very gently paying
particular attention to prevent the
machine from tipping up.
• Reduce speed:
• before changing direction
and during tight turns
• before tackling a slope, especially downhill,
to ensure a safe braking distance.
• Never switch to reverse gear to decrease
speed when going downhill: this could
cause loss of control of the machine,
especially on slippery ground.
Action
Release the drive pedal.
Test drive.
7.4
To start the machine:
1. Check that the transmission
2. Sit in the operator's position.
3. Fully insert the key (fig. 12.A).
a. For models type "I" and "II":
4. Wait for the machine's electrical check
5. Press the power button (Fig. 13.A).
6. Wait until the "Ready" icon
b. For models type "III":
4. Wait for the electrical check of the
5. Press the power button (Fig. 13.A).
6. Wait until the battery status icons (13.F
NOTE
At the end of the electrical check, the
headlights light up for a moment.
7.5
7.5.1 Drive and transfers
When moving the machine:
1. disengage the cutting means (fig. 13.B);
2. bring the cutting means assembly
3. Press the drive pedal to move the
4. Go to the work area.
EN - 22
The machine slows down and stops.
No unusual vibrations, no unusual
sound, correct operation of the
steering, controls and pedals.
START-UP
is engaged (par. 6.3).
to be performed, during which the icons
on the pushbutton panel will flash.
(fig. 13.K) is ON steady.
machine to be performed, during which
the icons present within the central
circular area of the pushbutton panel
light up (fig. 13III.F, 13III.Y, 13III.Z).
and 13.Y), the cutting height (13.W) and
the other active functions are illuminated.

OPERATION

to the highest position;
machine in the required direction of
driving and set the required speed by
adjusting the pressure on the pedal.
Result