Assembling The Valve - Bosch Rexroth II 3G Manual

26/48 Assembly
Special tool
Ordering address for
accessories and valves
Bosch Rexroth AG, M-.SED 6...XN..., RE 22049-XN-B/05.17
The special tool is intended for the actuation of the manual override.
Table 17: Special tool
Special tool
The addresses of our responsible sales organizations can be found on the Internet at
www.boschrexroth.com
and in the appendix 16.1 "List of addresses".

7.7 Assembling the valve

7.7.1 Installing the valve in the system
Faulty assembly of plug screws and lines!
Improperly fastened plug screws and lines may become loose during subsequent
operation and fly around due to the pressure. This may cause severe injuries!
▶ Only pressurize your system after all plug screws and lines have been completely
and properly mounted according to the specification.
Faulty fastening!
Mounting of the valve using valve mounting screws of reduced stability, insufficient
mounting or fastening at blocks and plates with insufficient stability may cause the
valve to become loose and fall down. Consequently, hydraulic fluid may leak and
lead to personal injuries and/or damage to property. Special care must be taken
with valves with suspended installation.
▶ Completely assemble the valve according to the assembly specifications using
suitable assembly aids.
▶ Only assemble the valve at blocks or plates suitable for the weight of the valve.
▶ Observe the tightening torques, screw stability and the minimum length of the
valve mounting screws.
Improper installation of the valve!
Improper installation of the valve causes an explosion hazard!
▶ The valve solenoid must not be installed close to charge generating processes.
▶ The valve is to be installed so that no impact stresses > 4 J can take effect.
Material number
R900024943
wARnInG