Table of Contents
Advertisement
Where to Place and How to Stabilize the Upright Lifecycle Bike
Read the entire manual before setting up the bike. After following all Safety Instructions, move the bike to the location
where it will be used. Allow a clearance of 2 ft. (0.6 m) in the directions the bike is accessed from and 3 ft. (1 m)
between the front or rear of the bike or any other objects.
After placing the unit in position, check the unit's stability by attempting to rock it from side to side. Any slight rocking
indicates that the unit must be leveled. Determine which foot is not resting completely on the floor. Loosen the jam nut
with an open-end M17 wrench and rotate the stabilizing foot to lower it. Verify that the bike is stable, and repeat the
adjustment as necessary until the unit no longer rocks. Lock the adjustment by tightening the jam nut against the
stabilizing bar.
2 ft. (0.6 m)
Page 8 of 29
3 ft. (1 m)
2 ft. (0.6 m)
3 ft. (1 m)
Item
1
2
Description
Jam Nut
Stabilizing Leg
Advertisement
Table of Contents
