Baofeng UV-82 User Manual page 26

ANI (display of the automatic device identification number
16
– this can only be set using a computer)
DTMFST (audibility of DTMF codes in the speaker of the
17
S-CODE (signal code group – can only be set by com-
18
SC-REV (operation of the device when it encounters
19
PTT-ID (S-CODE transmission when the PTT button is
20
21 PTT-LT (S-CODE transmission delay)
MDF-A (display of information in channel A mode – it can
22
MDF-B (display of information in channel B mode – it can
23
24 BCL (transmission blocking when the channel is busy)
25
26
27
28 MEMCH (saving channels in the device's memory)
29 DELCH (deleting channels from the device memory)
WT-LED (display backlighting color – standby mode)
30
RX-LED (display backlighting color – reception mode)
31
TX-LED (display backlighting color – transmission mode)
32
33
34
TX-AB (selection of transmission in dual watch / dual re-
35
36 STE (noise elimination during direct communication)
RP_STE (noise elimination during communication via a re-
37
38 RPT_RL (tone delay in repeater operation)
39 PONMGS (operation of the device after shutdown)
40 ROGER (end of transmission signal)
41
42
1750 Hz tone transmission
To start 1750 Hz tone transmission, press and hold the PTT-A or PTT-B button, and then press the
F button.
device)
puter)
a transmission while scanning)
pressed or released)
be set only with a computer)
be set only with a computer)
AUTOLK (automatic keypad lock)
SFT-D (frequency shift direction)
OFFSET (frequency shift value)
AL-MOD (alarm mode)
BAND (band selection)
ception mode)
peater)
A/B-BP (end of reception signal)
RESET (reset factory settings)
OFF/BLUE/ORANGE/PURPLE
OFF/BLUE/ORANGE/PURPLE
OFF/BLUE/ORANGE/PURPLE
25
BAOFENG UV-82
Instrukcja obsługi / User Manual
–
OFF/DT-ST/ANI-ST/DT+ANI
1,...,15 groups
TO/CO/SE
OFF/BOT/EOT/BOTH
0,...,30ms
FREQ/CH/NAME
FREQ/CH/NAME
OFF/ON
OFF/ON
OFF/+/-
00.000...69.990
000, ...127
000, ...127
SITE/TONE/CODE
VHF/UHF
OFF/A/B
OFF/ON
OFF/1,2,3...10
OFF/1,2,3...10
FULL/MGS
ON/OFF
OFF/A/B
VFO/ALL