Ac Power Connection; Remote Control - Sharp HT-SB200 Operation Manual

AC power connection

After checking all the connections have been made correctly,
connect the AC power cord to the AC power input jack, then to
the AC outlet.
■ Using with the AC/DC adaptor
1
Plug the AC power cord into the AC/DC adaptor.
2
Plug the AC/DC adaptor cable into the DC IN jack on
the speaker.
3
Plug the AC power cord into an AC outlet. The STAND-
BY indicator will turn RED when AC power is applied.
The power indicator will turn GREEN when the system
in "ON".
AC/DC Adaptor Cable
DC IN jack
(DC 12V)
AC power cord
AC Outlet
(AC 100 - 240 V ~ 50/60 Hz)
3
Notes:
●
Unplug the AC/DC adaptor from the AC outlet if the speaker
will not be used for a long period of time.
●
Use only the supplied AC/DC adaptor. Using other AC/DC
adaptor may cause an electric shock or fire.
2
RIGHT LEFT DC
LINE IN 2 LINE IN 1 INPUT
1
AC/DC Adaptor

Remote control

■ Battery installation
This product contains a CR Coin Lithium Battery which contains
Perchlorate Material – special handling may apply, California
residents, see www.dtsc.ca.gov/hazardouswaste/perchlorate/
1 Insert pin into the hole as shown and pull to open the
battery holder.
Back of
remote control
2 Remove the old battery from the battery holder, insert
the new battery and then slide the battery holder back
into the remote control.
Battery holder
Battery type
Locking tab
Polarity (+) symbol
Precautions for battery use:
●
Remove the battery if the speaker will not be used for a long
period of time. This will prevent potential damage due to
battery leakage.
HT-SB200
Pin
Positive (+) side up
15