Maintenance; Error Indicators And Warnings; Specifications - Sharp HT-SB200 Operation Manual

Maintenance

■ Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth.
Caution:
●
Do not use chemicals for cleaning (gasoline, paint thinner,
etc.). It may damage the cabinet finish.
●
Do not apply oil to the inside of each component. It may cause
malfunctions.

Error indicators and warnings

When you fail to perform operations properly, the following
messages are displayed on the speaker.
Display
●
or
or
●
Power indicator (blinks red)
(*): Should the same message appear even if the speaker is
unplugged and plugged in or is set to the stand-by mode and
on again, contact your local dealer where you purchased the
speaker.
Meaning
Malfunction of the surround
circuit. Place the speaker away
from noise source and plug the
AC power cord into another AC
outlet. (*)
When the protection circuit of the
amplifier is activated.
Specifications
As part of our policy of continuous improvement, SHARP
reserves the right to make design and specification changes for
product improvement without prior notice. The performance
specification figures indicated are nominal values of production
speaker. There may be some deviations from these values in
individual speaker.
■ General
Power source DC IN 12V
(AC 100 - 240 V ~ 50/60 Hz)
Power 10 W
consumption
Maximum output 32 W
power
Speaker 2.1-way Speaker System
Front Speakers: 1-1/2" (38 mm) Full Range
Subwoofer: 2-1/4" (57 mm) Woofer (x4)
Audio output Speakers: 12 ohms/channel
terminals Subwoofer: 3 ohms
(12 ohms x 4 parallel connection)
Input terminals Analog input (LINE 1):
RCA type x 1pair (L/R)
500 mV / 47 kohms
Analog input (LINE 2):
Stereo mini jack Ø 3.5 mm
100 mV / 47 kohms
Dimensions Width: 31-1/2" (800 mm)
Height: 3-3/4" (96 mm)
Depth: 2-3/4" (70 mm)
Weight 3.86 lbs. (1.75 kg)
4A: AC/DC adaptor
HT-SB200
19