Mounting The Kombitool; Mounting The Cutting Blade - Stihl FCS-KM Instruction Manual

English
► Push the drive tube (3) through the clamp and
into the gearbox – turn the gearbox back and
forth as necessary.
► Once the end of the drive tube is inserted
beyond the slot (see arrow) in the clamp (5),
push it fully home as far as stop.
► Tighten down the clamp screw as far as stop.
2
1
► Line up the gearbox (2) on the drive tube (3)
so that the lug (arrow) points vertically
upwards when the depth wheel (4) is vertical.
► Tighten down the clamp screw (1) firmly.
7

Mounting the KombiTool

2
► Push the lug (1) on the drive tube into the
slot (2) in the coupling sleeve as far as stop.
When correctly installed, the red line (3) (arrow
point) must be flush with the end of the coupling
sleeve.
► Tighten down the star knob (4) firmly.
10
3
4
1
3
4
7.1 Removing the KombiTool
► Reverse the above sequence to remove the
drive tube.
8

Mounting the Cutting Blade

► Lay the power edger on its back so that the
blade mounting (1) faces up.
2
► Insert the stop pin (2) into the hole (3) as far
as stop – apply slight pressure and turn back
and forth together with the thrust plate (4) until
the pin slips into position and blocks the shaft.
► Fit the combination wrench (5) on the
screw (6).
► Loosen the screw clockwise (left-hand thread)
and take it out.
7 Mounting the KombiTool
5
6
4
3
0458-472-0121-E