Table of Contents
Advertisement
6
Troubleshooting
Check the troubleshooting section every time a process fails.
When a process fails, check that:
●
The emergency button is not pressed, and the station is rearmed.
●
The station's pressure is within the limits.
Material management and material filling
Use the troubleshooting tables to locate your issue, then follow the manual recovery steps to resolve it.
For feed system (manual)
Workflow
Sieve-load material
feeding from manual
aspiration hose
Sieve-load material
feeding from manual
aspiration hose
Sieve-load material
feeding from manual
aspiration hose
104
Chapter 6 Troubleshooting
Step
User vacuums powder
using manual aspiration
hose
User vacuums powder
using manual aspiration
hose
User vacuums powder
using manual aspiration
hose
Failure
Continuous slow
aspiration.
Low Flow Rate
0035-0013-0386 Feeding
System - Transport from
aspiration - Low flow rate
Manual aspiration stopped
by internal tank (tank full)
Manual aspiration hose is
dirty
0035-0013-0386 Feeding
System - Transport from
aspiration - Low flow rate
Manual recovery
Move the hose away
from the powder for a
few seconds. Continue
the manual aspiration
workflow. If necessary,
cover and uncover the
hose inlet repeatedly with
your hand and shake the
hose in order to unclog any
material.
Check that the filters are
full of powder (check F9,
first). Clean the filters if
required or replace them if
HEPA is compromised.
Carefully place the hose
into parking position facing
upwards (note that the
pipe will be full of powder).
Clean any powder spillage.
The pipes cannot be
cleaned until the mixer is
emptied (after the material
has been loaded into the
build unit).
Cover and uncover the
hose inlet repeatedly with
your hand.
Advertisement
Table of Contents
Troubleshooting
