Table of Contents
Advertisement
Steps
1. Connect the I/O daughter-board cable to the connector on the I/O daughter-board and close the latch.
2. Adhere the tape to secure the I/O daughter-board cable to the connector on the I/O daughter-board.
3. Carefully route the I/O daughter-board cable through the routing guides on palm-rest and keyboard assembly.
4. Connect the I/O daughter-board cable to the connector on the system board and close the latch.
5. Adhere the tape to secure the I/O daughter-board cable to the connector on the system board.
6. Adhere the tape to secure the I/O daughter-board cable to the fan.
Next steps
1. Install the
base
cover.
2. Follow the procedure in
I/O daughter-board
Removing the I/O daughter-board
CAUTION:
The information in this section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
3. Remove the
I/O daughter-board
About this task
The following images indicate the location of the I/O daughter-board and provide a visual representation of the removal
procedure.
After working inside your
Before working inside your
cable.
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
63
Advertisement
Table of Contents
