Before First Use - Zanussi ZW74PDBI User Manual

Universal pow-
Programme
Denim
Wool/Hand-
wash
1) At temperature higher than 60 °C the use of powder detergent is recommended.
▲ = Recommended
SETTINGS
ACOUSTIC SIGNALS
This appliance has different acoustic signals, that
operate when:
• You activate the appliance (special short tune).
• You deactivate the appliance (special short
tune).
• You touch the buttons (click sound).
• You make an invalid selection (3 short sounds).
• The programme is completed (sequence of
sounds for about 2 minutes).
• The appliance has a malfunction (sequence of
short sounds for about 5 minutes).
To deactivate/activate the acoustic signals set a
one of the programme, touch the Flextime and the
Delay Start buttons simultaneously for about 2
seconds. The display shows On/Off
If you deactivate the acoustic signals,
they continue to operate when the
appliance has a malfunction.
OPERATING HOURS COUNTER
It is possible to visualise the total operating time of
the appliance in hours, starting from the first
switching on. This value will count operating time of
the cycles (does not include pauses, delayed start
time). To visualise this value, proceed as follows:
1. Switch the appliance on by pressing On/Off
button.
2. Turn the programme knob to the Eco 40-60
programme (1st position clockwise).
3. Press and hold the Flextime and Delay Start
buttons for some seconds (within 10 seconds
after the switching on. After these 10 seconds,

BEFORE FIRST USE

1. Make sure that the electrical power is available
and the water tap is open.
24
Liquid Universal
1)
der
-- --
-- --
Liquid for colour- Delicates wool-
eds
▲
--
-- = Not recommended
the key combination activates and deactivates
the acoustic signals).
4. After 3 seconds the total hours operated by the
appliance are shown in the display: e.g. 1276
hours, the display shows the text Hr for 2
seconds, 12 (thousands and hundreds) for 2
seconds and 76 (tens and units).
If the procedure does not work (due to
timeout, wrong programme dial
position or wrong keys combination),
switch the appliance off and repeat
sequence from the beginning.
FACTORY RESET
This function allows to restore the factory default
options. To activate this option follow steps below:
1. Switch the appliance on by pressing On/Off
button.
2. Turn the programme knob to the Synthetics
programme (3rd position clockwise).
3. Press and hold the Flextime and Delay Start
buttons for some seconds (within 10 seconds
after the switching on. After these 10 seconds,
the key combination activates and deactivates
the acoustic signals).
4. The display will show
seconds.
If the procedure does not work (due to
timeout, wrong programme dial
position or wrong keys combination),
switch the appliance off and repeat
sequence from the beginning.
Special
lens
▲ ▲
▲ ▲
for about 5