Enabling / Disabling An Extra Rinse; Brightness; Setting The Water Hardness - Electrolux Talkie Service Manual

9.6 Enabling / disabling an extra rinse

The following procedure can be used to include a supplementary rinse in all wash programmes,
which improves rinsing
To add an extra rinse:
1. Access the diagnostic mode (see 9.1)
2. Press button Options repeatedly until the following message appears on the display:
EXTRA RINSE NO (when NO flashes, the extra rinse is disabled)
3. Press button Ok/Start to toggle the setting
The word SI flashes on the display (extra rinse is enabled)
4. To confirm:
Press button Options
OR wait 60 seconds
OR turn the appliance off by pressing button S0

9.7 Brightness

To adjust the brightness of the display:
1. Access the diagnostic mode (see 9.1)
2. Press button Options repeatedly until the following message appears on the display:
BRIGHTNESS 5 (the number 5 flashes)
3. Press button Ok/Start repeatedly until the desired brightness is obtained on the display
The new brightness value flashes on the display
4. To confirm
Press button Options
OR wait 60 seconds
OR turn the appliance off by pressing button S0

9.8 Setting the water hardness

The count for "as needed" execution of the regeneration cycle is made by the electronic control
system based on the duration of the fill phases and thus on the quantity of water loaded. This function
optimizes this system to compensate for the hardness of the water. The adjustment is made over 10 levels,
as described in section 6.11. If the lowest level of water hardness is set, regeneration is not performed and
the advisory ADD SALT will not appear on the display.
To set the system to compensate for the hardness of the water:
1. Access the diagnostic mode (see 9.1)
2. Press button Options repeatedly until the following message appears on the display:
WATER HARDNESS 1 (1 flashes)
3. Press button Ok/Start repeatedly until the desired water hardness value appears on the display
The new water hardness value flashes on the display
4. To confirm
Press button Options
OR wait 60 seconds
OR turn the appliance off by pressing button S0.
action.
33