Air Shroud; Drive Bay Installation/Removal; Accessing The Drive Bays - Supero AS-1041M-T2 Plus User Manual

AS1041M-T2+ User's Manual

Air Shroud

A mylar air shroud is used in the chassis to increase the effi ciency of the cooling
system. It should be kept in place whenever the system is running.
The air shroud fi ts over the entire motherboard area. See Figure 6-2.
6-4

Drive Bay Installation/Removal

Accessing the Drive Bays

SATA Drives: Because of their hotswap capability, you do not need to access the
inside of the chassis or power down the system to install or replace SATA drives.
Proceed to the next section for instructions.
DVD-ROM/Floppy Disk Drives: For installing/removing a DVD-ROM or fl oppy disk
drive, you will need to gain access to the inside of the 1041M-T2+ by removing the
top cover of the chassis. Proceed to the "DVD-ROM and Floppy Drive Installation"
section later in this chapter for instructions.
Note: Only "slim" DVD-ROM and fl oppy drives will fi t into the 1041M-T2+.
Figure 6-2. Installing the Air Shroud
6-4