Installing The Server Into The Rack; Installing The Server Into A Telco Rack - Supero AS-1041M-T2 Plus User Manual

Supermicro as-1041m-t2 plus servers: user guide

Hide thumbs Also See for AS-1041M-T2 Plus:

Table of Contents

AS1041M-T2+ User's Manual

Installing the Server into the Rack

You should now have rails attached to both the chassis and the rack unit. The next

step is to install the server into the rack. Do this by lining up the rear of the chas-

sis rails with the front of the rack rails. Slide the chassis rails into the rack rails,

keeping the pressure even on both sides (you may have to depress the locking

tabs when inserting). See Figure 2-3.

When the server has been pushed completely into the rack, you should hear the

locking tabs "click". Finish by inserting and tightening the thumbscrews that hold

the front of the server to the rack.

To install the server into a Telco type rack, use two L-shaped brackets on either

side of the chassis (four total). First, determine how far the server will extend out

the front of the rack. Larger chassis should be positioned to balance the weight

between front and back. If a bezel is included on your server, remove it. Then at-

Figure 2-3. Installing the Server into a Rack

2-6

Table of Contents

As1041m-t2+