Table of Contents
Advertisement
Advanced Serverboard Setup
This chapter covers the steps required to install processors and heatsinks to the
H8QMi-2+ serverboard, connect the data and power cables and install add-on
cards. All serverboard jumpers and connections are described and a layout and
quick reference chart are included in this chapter. Remember to close the chas-
sis completely when you have fi nished working on the serverboard to protect and
cool the system suffi ciently.
5-1
Handling the Serverboard
Electrostatic discharge (ESD) can damage electronic com ponents. To prevent
damage to printed circuit boards, it is important to handle them very carefully (see
Chapter 4). Also note that the size and weight of the serverboard can cause it to
bend if handled improperly, which may result in damage.
To prevent the serverboard from bending, keep one hand under the center of the
board to support it when handling. The following measures are generally suffi cient
to protect your equipment from static discharge.
Precautions
•
Use a grounded wrist strap designed to prevent static discharge.
•
Touch a grounded metal object before removing any board from its antistatic
bag.
•
Handle a board by its edges only; do not touch its components, peripheral chips,
memory modules or gold contacts.
•
When handling chips or modules, avoid touching their pins.
•
Put the serverboard, add-on cards and peripherals back into their antistatic
bags when not in use.
Unpacking
The serverboard is shipped in antistatic packaging to avoid static damage. When
unpacking the board, make sure the person handling it is static protected.
Chapter 5: Advanced Serverboard Setup
Chapter 5
5-1
Advertisement
Table of Contents
