Table of Contents
Advertisement
38
www.aeg.com
12.6 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Inicio/Pausa button,
the maximum declared load indicator
goes off, the indicator
ProSense starts the laundry load
detection:
1. The appliance detects the load in the
first 30 seconds: the indicator
comes on and the indicator
flashes, the drum rotates shortly.
2. The appliance adjusts automatically
the programme duration to the load
to achieve perfect washing results in
the minimum possible time. The
programme duration could increase
or decrease.
At the end of the load detection, if
laundry load is below the maximum
declared weight for selected
programme, the display shows the
new programme duration. After
further 30 seconds, the water filling
starts.
At the end of the load detection, in case
of drum overload, the indicator
steady on and the indicator
flashing in the display.
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Inicio/Pausa button to start the
programme again. The ProSense phase
can be repeated up to three times (see
point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
flashes, the
12.7 Programme phase
indicators
When the programme starts the indicator
of the running phase flashes and the
other phase indicators are steady on.
E.g. the washing or pre wash phase is
running:
When the phase ends the relevant
indicator stops flashing and is steady on.
is
The next phase indicator starts flashing.
is
E.g. the rinse phase is running:
12.8 Interrupting a
programme and changing the
options
When the programme is running, you
can change only some options:
1. Touch the button Inicio/Pausa.
The related indicator flashes.
2. Change the options. The given
3. Touch the button Inicio/Pausa again.
The washing programme continues.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
TheProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
The ProSense is not
available with some
programmes, such as Lana/
Lãs, Aclarado, Centrif. and
programmes with short
cycles.
.
information in the display changes
accordingly.
.
Advertisement
Table of Contents
